Memory dump at 0x400fdcf8: ffffffff ffffffff 3df03dd4 ![]() I tried to do it but in the logs I’m seeing this : Guru Meditation Error: Core 0 panic'ed (IllegalInstruction). These values are with the ESP’s GND, so do I have to connect ESP32’s GND to PSU’s GND ? When checking with a multimeter, I can see the voltage between the ESP Pins G12 and GND as following : I unfortunately don’t have an oscilloscope (Or LED) to check if the PWM signal is good or not. When I change speed, I can see the ESP32’s onboard LED flash, I see logs in ESPHome but nothing is happening on the fan, it stays at full speed. I suspect the appropriate module is simply missing.The upload is successful and I see my fan.network_cabinet_fan in Home Assistant. pwmconfig reports the w83627hf chip and there is also the appropriate section in /etc/nf, changes in the config file are reflected when I call /usr/bin/sensors. You may also need to increase the fan divisors. Make sure you have a 3-wire fan connected. There are no working fan sensors, all readings are 0. Hwmon0/device/fan3_input current speed: 0. Hwmon0/device/fan2_input current speed: 0. Hwmon0/device/fan1_input current speed: 0. Giving the fans some time to reach full speed. Physically verify that the fans have been to full speed ![]() However, it is ** very important ** that you The program will attempt to restore each fan to full speedĪfter testing. We will attempt to briefly stop each fan using the pwm controls. Note that many motherboards do not have pwmĬircuitry installed, even if your sensor chip supports pwm. This program will search your sensors for pulse width modulation (pwm)Ĭontrols, and test each one to see if it controls a fan on Thanks for the tip, in the meantime here the output of pwmconfig, the output looks strange to pwmconfig
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |